top of page

Electronics Testing Equipment for RF Tuning and Diagnostics

REGULUS provides electronics testing equipment for RF tuning, signal analysis, diagnostics, and electrical verification during PCB assembly and electronics manufacturing. Available resources support analog and digital products using radio test platforms, oscilloscopes, signal generators, spectrum analyzers, programmable DC power supplies, and digital multimeters.

​

These diagnostic resources can be integrated into our manufacturing workflow to support signal-integrity verification, radio communication testing, tuning, and troubleshooting according to your product specifications, test procedures, and acceptance criteria. They can be applied at the PCBA stage and, where applicable, after final assembly for product-level RF or electrical verification.

RF Tuning and Signal Diagnostics

Our tuning and diagnostic equipment supports calibration, RF troubleshooting, and defined radio test requirements for wireless communication products at both PCBA and completed-product stages, depending on the available test interfaces and project requirements. Radio test platforms, including the 3920 Aeroflex / Viavi and CMS52 Rohde & Schwarz service monitors, can be used for radio testing and tuning according to the applicable product specifications and test procedures.

​

For signal analysis, the MDO3000 Tektronix mixed domain oscilloscope provides simultaneous time- and frequency-domain views to support troubleshooting, signal analysis, and diagnostic evaluation.

Analog and Digital  Radio Test Platforms
Radiocommunication  Service Monitors
Mixed Domain  Oscilloscopes

3920 Aeroflex / Viavi

Analog and Digital 
Radio Test Platform

CMS52 Rohde & Schwarz

Radio Communication 
Service Monitor

MDO3000 Tektronix

Mixed Domain 
Oscilloscope

RF Signal and Electrical Measurement Resources

RF signal generators support controlled signal generation across the equipment's specified frequency range, with phase-noise characteristics considered according to the instrument configuration and test requirements. Spectrum analyzers with tracking generators support frequency-domain analysis, spectral evaluation, and filter characterization. ​These instruments can be used at the PCBA stage and, where suitable test access is available, after final assembly for product-level RF and electrical verification.

​

Beyond RF testing, our equipment resources also support fundamental electrical verification:

  • Voltage and Current Measurement: A dual-display digital multimeter supports voltage and current measurements during testing, troubleshooting, and verification.

  • Programmable DC Power Supply: Programmable DC power supplies provide controlled power conditions for bench testing, tuning, and electrical verification.

RF Signal Generators

SMB100B Rohde & Schwarz

8 kHz - 3 GHz 50 Ω
RF Signal Generator

Spectrum Analyzers  with Tracking Generators

FPC1500 Rohde & Schwarz

Spectrum Analyzer with Tracking Generator

Programmable DC PSU Dual Display Digital Multimeter

Other Devices

Programmable DC PSU
Dual-Display Digital Multimeter

Review Your RF Tuning and Testing Requirements

Preparing an RF or electronics testing project? Please provide your product or PCBA information, frequency bands or radio requirements, test procedure, required measurements and limits, test interfaces or fixtures, quantities, and target schedule. Please also indicate whether testing is required at the PCBA stage, after final assembly, or at both stages.

​

We will review the available RF tuning, diagnostic, signal-analysis, and electrical testing resources against your project requirements.

​

For related production and quality resources, see our Electronic Assembly Line and Quality Assurance pages.

Regulus Electronics Ltd.​​

Knowledge Centers

> PCB Assembly Guide

​> Box Build Assembly Guide

TEL: +886 (2) 2760 1601

FAX: +886 (2) 2277 1827

Email: sales@reguluspec.com

WhatsApp: Regulus Taiwan​

2026. All rights reserved by Regulus Electronics Ltd. | Privacy Policy | 

bottom of page